, ,

PerfoBox QuadPlexer 1500W 7-14-21-28 MHz


Out of stock

The PerfoBox QuadPlexer lets you connect up to four transceivers to a multi-band antenna for simultaneous operation (additional band pass filters required).

Delivery time on this item is 4-6 weeks.

627.00 $

  • EUR: 579.00 €
  • SEK: 6 734 kr

Out of stock

Sometimes referred to as combiners or splitters, these N-way plexers are basically band-pass filters, simultaneously passing RF in both directions through the common connector, while the filters provide a high degree of isolation between ports.

  • TX and RX from two or three or four radios at the same time into a single multiband antenna.
  • Allow a single coax run into two or three or four antennas at the top of the tower or separate in-band antenna site for advanced contesting, and few radios at the bottom, by using a N – plexer at both ends of the coax run, avoiding cost and weight and hassle of installing numerous coax cables.

Additional band pass filter are required for each input to isolate and protect each transceiver and reduce interference. We recommend using the ultimate performance PerfoBox Band Pass Filters filters for this purpose.

Datasheet, QuadPlexer Perfo Box-1500, 7-14-21-28

PerfoBox QuadPlexer 1500W Typical Specifications

Impedance: 50 Ohm
Maximum ICAS power per band port: 1500 W
Maximum ICAS power at antenna port: 3000 W
VSWR: typical ≤1: 1,2
Cooling fans: 12VDC, 2200RPM, 29.9CFM
Size: 360x240x110 mm / 14”х10”х4”
Net weight: ≤3,2 kg / 7,5 lbs


SKU: PB-QP1500 Categories: , ,
Weight 4.5 kg
Dimensions 36 × 24 × 11 cm